QDY hook bridge casting crane
QDY hook bridge casting crane is mainly used for lifting molten metal metallurgy, casting and other places. The working level of the whole machine is A7, and heat insulation device is added at the bottom of the main beam. The assembly and test of the crane is in conformity with the No. 375 document issued by the General Administration of Quality Supervision, Inspection and Quarantine. Other places for lifting molten non-metallic materials and lifting hot solid metal are also referred to.
1. The crane power supply is three-phase alternating current, the rated frequency is 50HZ, and the rated voltage is 380V;
2. The working environment temperature is -10 ° C ~ 60 ° C;
3. The relative humidity does not exceed 50% at a temperature of 40 ° C;
4. If the above requirements are exceeded, the user's requirements shall be implemented according to the terms of the order contract.
Ordering Information: When ordering or signing a contract, the user must clearly describe the technical parameters (rated lifting capacity, lifting height, span, etc.) of the machine in order to provide products that meet the working conditions and working conditions.
- Structure And Working Principle Of Grab Bridge ...
- Attention Of Grab Bridge Crane
- Use Of Grab Bridge Crane
- Classification Of Bucket Crane
- General Purpose Bridge Crane Structure
- Analysis Of The Heating Causes Of Slip Ring Motor
- The Method Of Heat Treatment Of Slip Ring Motor...
- Use Of Slip Ring Motor
- Main Classification Of Dc Motor
- Dc Motor Excitation Mode
- Structure Of Gantry Crane
- Port Gantry Crane Introduction
- Lifting Electromagnet Basic Components Electrom...
- Common Types Of Grab Cranes
- C-type Spreader
- Safety Technical Requirements For Crane Hooks
- Basic Knowledge Of Double Girder Bridge Crane
- Gantry Cranes Are Installed Outdoors. Precautions
- The Working Principle Of The Grab Crane
- Mining Bridge Crane